Control planning

DMX Address and DIP Switch Calculator

Plan start addresses and binary address bits for fixtures within one DMX universe.

Project inputs

Plan DMX fixture addresses

Plan one universe at a time. Fixtures must fit entirely within channels 1–512.

Planning result

Your estimate

Enter your project inputs to calculate a plan.

DIP output shows binary address bits only. Switch order, ON direction, and whether switch 10 is an address bit or a mode switch vary by device. Confirm the fixture manual; do not use this as a universal wiring guide.

Estimate controller capacity →

How to use the DMX address calculator

Find the fixture’s channel footprint in the manual for the operating mode you will actually use. Enter the first DMX address, channels per fixture and the number of identical fixtures. The result lists each consecutive address range for a single universe.

Each next start address equals the previous start plus its channel count. The last channel of every fixture must be no greater than 512. If the requested fixtures do not fit, the tool asks you to revise the plan; plan additional universes separately and confirm the controller’s patching rules.

Example: three fixtures using four channels

With a start address of 1 and four channels per fixture, the ranges are 1–4, 5–8 and 9–12. Their start addresses are 1, 5 and 9. Entering a different starting address shifts the entire sequence; the calculator does not assign universe numbers or handle mixed fixture modes in the same run.

The displayed DIP numbers show the binary bits that sum to each start address. For example, address 5 has bits 1 and 3 set (1 + 4). This is an illustration of a binary scheme, not a verified switch setting for a particular device.

Check the device before setting DIP switches

Fixtures can use different switch numbering, ON directions and addressing conventions. Switch 10 may be used for a mode rather than an address bit, and some devices may not support every address shown by a generic binary calculator. Consult the actual fixture or decoder manual, particularly for address 512.

Confirm fixture mode, channel footprint, universe and patch in the controller or lighting software. This calculator assigns consecutive, non-overlapping addresses; deliberate shared addresses and split-universe configurations require a separate design.

Frequently asked questions

What happens when my fixtures exceed channel 512?
The tool stops instead of silently moving a fixture to another universe. Reduce the requested count or plan another universe separately using the limits of your actual controller.
Can I use the DIP output for any DMX fixture?
No. It is binary reference information only. The device manual determines whether a fixture uses DIP switches, the bit mapping, ON direction and special switch functions.

Continue planning your project

Reference: Martin: fixture DIP switch addressing example. Confirm design assumptions with current equipment documentation.