Pixel LED Grid and Spacing Calculator
Estimate a rectangular grid of pixel points from the usable span and chosen spacing.
Your estimate
Enter your project inputs to calculate a plan.
This is a regular rectangular point grid, not a brightness, viewing-distance or engineering design. Check edges, installation clearances, mounting, obstruction and the selected product before ordering.
Estimate controller capacity →How to estimate a rectangular pixel grid
Measure the usable horizontal and vertical centre-to-centre spans: the maximum distances between the first and last pixel centres after allowing for project edges and obstructions. Enter both spans in metres and your desired spacing in centimetres. This tool uses the same spacing horizontally and vertically.
The first point sits at the starting corner. Columns = floor(horizontal span ÷ spacing) + 1; rows use the same rule for the vertical span. Multiply the two counts to estimate the total. If the span is not an exact multiple, the last point stops before the available edge rather than being pushed beyond it.
Example: a 2 m by 1 m usable span
At 50 cm spacing, 2 m fits four complete intervals and therefore five columns. The 1 m vertical span fits two intervals and three rows. The result is 5 × 3 = 15 points, with an occupied centre-to-centre span of 2 m by 1 m.
This is not the same as dividing a wall area by a fixture’s dimensions. The input excludes the fixture’s overhang and mounting clearance; adjust those boundaries before calculating. A strip’s LEDs and individually controllable pixels may also be grouped differently.
From point count to a project brief
Confirm fixture size, spacing, orientation, mounting and available power with the product documentation. Account for obstacles, service access and any spares separately. Non-rectangular layouts, staggered patterns and uneven spacing require their own layout.
Use the estimate as an input to controller-capacity planning, then check the actual fixture channel mode and controller outputs. Grid count alone does not establish brightness, visual resolution, viewing distance, wiring or installation compliance.
Frequently asked questions
- Does the calculator include a border or installation margin?
- No. Enter the usable centre-to-centre span after subtracting any project-specific edge and mounting clearances.
- Can I use different horizontal and vertical spacing?
- This version uses one spacing in both directions. For a non-square grid, calculate the two dimensions separately and verify the resulting layout before ordering.